Oct 13, 2020
IPv6 support has been added to Access It! Universal.NET 5.1 and is supported on the following devices:
- EP-Series controllers min f/w 1.184
- M5-IC min f/w 1.184
- Open a web browser and go to EP-IPADDRESS
Where EP-IPADDRESS is the IP address of the pre-programmed EP or M5 panel. - Click on Click Here to Login
- Click on Continue to this website (not recommended)
- On the panel, turn dip switch 1 to the on position
- Enter a Username of admin
- Enter a Password of password
- Click Host Comm from the left hand menu
- Select (check) the option Use IPv6 Only
- Click Accept
- Click Apply Setting from the left hand menu
- On the panel, turn dip switch 1 to the off position
- Click Apply, Reboot button
- Wait 60 seconds for EP-1502 to reboot
Access It! Universal SCP Setup
- Navigate to the SCPs section within the Hardware Tree
- Select New from the toolbar
- Set SCP Name accordingly
- Set Model accordingly
- Set SCP Timezone accordingly
- Select the Comm tab
- Set the Channel to any available IP Server channel
- Enter a valid IPv6 address
- Enter the TCP port to communicate over (default is 3001)
- Click Save