Custom Supervisory Resistance Values


Overview

Access It! Universal V4 now supports the ability to define a custom resistance values for use in supervised inputs. Previous versions of Access It! Universal only supported supervised circuits of 1K/2K.

Implementation

SCP

  1. Navigate to the Hardware tree (Main | Hardware)
  2. Select SCPs
  3. In the right hand pane, edit the EP requiring custom resistance values
  4. Select the Supervised Inputs tab
  5. Click Edit Supervised Input Tables
  6. Click new
  7. Enter a friendly name for the supervised resistance range
  8. Enter Low/High values in Ohms for Active, Secure, and Fault conditions
    Access It! Universal will report a generic supervisory fault for all shorted circuit, foreign voltage, open circuit, or ground fault conditions.
  9. Click OK
  10. Click Save
  11. Apply the newly created resistance table to the SCP
  12. Click Save

Reader

  1. Navigate to the Hardware tree (Main | Hardware)
  2. Select Installed Readers
  3. In the right hand pane, edit the Reader requiring custom supervisory resistance values
  4. Select the Door Settings tab
  5. Select the custom created supervisory table within the Door Contact and/or the Request to Exit Configuration pick list
  6. Click Save

Input

  1. Navigate to the Hardware tree (Main | Hardware)
  2. Select Installed Inputs
  3. In the right hand pane, edit the Input requiring custom supervisory resistance values
  4. Select the custom created supervisory table within the Input Configuration pick list
  5. Click Save

  • 232
  • 29-Apr-2014
  • 4541 Views